Basic Fence Building For Your Home By Jim Ames At Isnare.com Ezine Articles

A fenced in yard is a great asset to a home. Unfortunately, paying a builder to install one for you can be very costly. Here are some basic things that you need to know in order to build your own fence.

Designing your own fence does not have to be fancy. You simply need to decide what type of fence you want to build . Think about whether you want a traditional picket fence or perhaps you want a privacy fence. Plot out where your gate will be located, where you will start the first post, how far apart the posts will be, and how high the fence will be.

Next you need to mark a line to follow where the posts will be. This doesn't need to be complicated. Just figure out where your end posts will be and start there. You want to make sure that your line is straight or your fence will be crooked and it will not be as sturdy as it should be.

Your posts should be made from treated wood. If your wood was not treated before you bought it, you will definitely want to take the time to treat it yourself. Make sure the posts sit with the treatment solution for an entire day to be sure they are well saturated before you put them in the ground.

You will want your posts to be firmly anchored in the ground. In order to achieve this, you should dig the holes deep enough to bury at least one third of the post. You can use a manual post hole digger or you can rent a mechanical one. If you have a large yard, a mechanical one will be a lot faster. Once you have dug the holes. Drop a shovelful or two of gravel into the hole to make a stable bed for the post to rest on.

When the holes are dug it is time to install the posts. Make sure that you secure the posts with a brace to ensure that they are perfectly upright while you pack dirt or concrete around them. If they are slanted, it will mess up the line of your fence and could promote rotting of the wood. Give the dirt or concrete enough time to set up before you take down the braces

After you have the posts firmly in place it is time to add the rails. Many people build their fence in sections and then attach each section to the posts. This can be advantageous because you can build on a more stable surface and be sure that all of your rails are perfectly straight and even.

If you follow these few simple steps, you will have a beautiful fence that you built yourself for much less than you would spend paying someone to install it for you.

For more information about fencing, visit: http://www.tipsonfences.com

Published At: Isnare Free Articles Directory http://www.isnare.com
Permanent Link: http://www.isnare.com/?aid=157822&ca=Home+Management

Important Notice DISCLAIMER: All information, content, and data in this article are sole opinions and/or findings of the individual user or organization that registered and submitted this article at Isnare.com without any fee. The article is strictly for educational or entertainment purposes only and should not be used in any way, implemented or applied without consultation from a professional. We at Isnare.com do not, in anyway, contribute or include our own findings, facts and opinions in any articles presented in this site. Publishing this article does not constitute Isnare.com's support or sponsorship for this article. Isnare.com is an article publishing service. Please read our Terms of Service for more information.