iSnare.com - Free Content Articles Directory
Authors Contents [Advanced Search][Add OpenSearch][Job Search]
Distribute your articles to thousands of article sites for only $2 and below! Read more...

Index  Computers and Technology
 

Cisco CCNP Certification / BCMSN Exam Tutorial: The HSRP Mac Address

 
[ Contact the Author] [ Send to a Friend] [ Article Publisher] [Make PDF] [ Print] [ Bookmark & Share]
 
Read our Terms of Service before reprinting this article. The submitter specified above has claimed the rights to this article.
Chris Bryant

To pass the BCMSN exam and earn your CCNP, you've got to know HSRP inside and out! Part of that is knowing how the MAC address of the virtual router is derived, and another part is knowing how to change this address. We'll look at both features in this tutorial.

We've got two routers on a segment running HSRP, so first we need to find out what the MAC address of the HSRP virtual router is. The show command for HSRP is show standby, and it's the first command you should run while configuring and troubleshooting HSRP. Let's run it on both routers and compare results.

R2#show standby

Ethernet0 - Group 5

Local state is Standby, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 0.776

Virtual IP address is 172.12.23.10 configured

Active router is 172.12.23.3, priority 100 expires in 9.568

Standby router is local

1 state changes, last state change 00:00:22

R3#show standby

Ethernet0 - Group 5

Local state is Active, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 2.592

Virtual IP address is 172.12.23.10 configured

Active router is local

Standby router is 172.12.23.2 expires in 8.020

Virtual mac address is 0000.0c07.ac05

2 state changes, last state change 00:02:08

R3 is in Active state, while R2 is in Standby. The hosts are using the 172.12.123.10 address as their gateway, but R3 is actually handling the workload. R2 will take over if R3 becomes unavailable.

An IP address was statically assigned to the virtual router, but not a MAC address. However, there is a MAC address under the show standby output on R3, the active router. How did the HSRP process arrive at a MAC of 00-00-0c-07-ac-05?

Well, most of the work is already done before the configuration is even begun. The MAC address 00-00-0c-07-ac-xx is reserved for HSRP, and xx is the group number in hexadecimal. That's a good skill to have for the exam, so make sure you're comfortable with hex conversions. The group number is 5, which is expressed as 05 with a two-bit hex character. If the group number had been 17, we'd see 11 at the end of the MAC address - one unit of 16, one unit of 1.

On rare occasions, you may have to change the MAC address assigned to the virtual router. This is done with the standby mac-address command. Just make sure you're not duplicating a MAC address that's already on your network!

R2(config-if)#standby 5 mac-address 0000.1111.2222

1d12h: %STANDBY-6-STATECHANGE: Ethernet0 Group 5 state Active -> Learn

R2#show standby

Ethernet0 - Group 5

Local state is Active, priority 150, may preempt

Hellotime 4 sec, holdtime 12 sec

Next hello sent in 3.476

Virtual IP address is 172.12.23.10 configured

Active router is local

Standby router is 172.12.23.3 expires in 10.204

Virtual mac address is 0000.1111.2222 configured

4 state changes, last state change 00:00:00

1d12h: %STANDBY-6-STATECHANGE: Ethernet0 Group 5 state Listen -> Active

The MAC address will take a few seconds to change, and the HSRP routers will go into Learn state for that time period.

A real-world HSRP troubleshooting note: If you see constant state changes with your HSRP configuration, do what you should always do when troubleshooting - check the physical layer first. Best of luck on your BCMSN exam!

Important NoticeDISCLAIMER: All information, content, and data in this article are sole opinions and/or findings of the individual user or organization that registered and submitted this article at Isnare.com without any fee. The article is strictly for educational or entertainment purposes only and should not be used in any way, implemented or applied without consultation from a professional. We at Isnare.com do not, in anyway, contribute or include our own findings, facts and opinions in any articles presented in this site. Publishing this article does not constitute Isnare.com's support or sponsorship for this article. Isnare.com is an article publishing service. Please read our Terms of Service for more information.

Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage (http://www.thebryantadvantage.com), home of free CCNA and CCNP tutorials! For my FREE "How To Pass The CCNA" or "CCNP" ebook, visit the website and download your copies. Get your CCNA study guide from The Bryant Advantage!
Article Tags: address [See Dictionary], mac [See Dictionary], state [See Dictionary]
Got a question about this article? Ask the community!
Article published on May 30, 2006 at Isnare.com
 
Rate this article:

CISCO CCNA, CCENT, And CCNP Home Lab Study: The DTE/DCE Cable
Submitted by: Chris Bryant

More Cisco CCNA, CCENT, and CCNP candidates than ever before are putting together their own home labs for their certification exam study, and that's a great trend - there's nothing like learning on the real thing...

Cisco 640-802 Ccna And Ccent Certification: Ram, Rom, Nvram, Flash, And The Boot Process
Submitted by: Chris Bryant

An important part of your Cisco CCENT and CCNA certification studies is learning the differences between RAM, ROM, NVRAM, and Flash memory...

Cisco CCNA / CCENT Certification Exam Training: Physical And Virtual Lans
Submitted by: Chris Bryant

Earning your Cisco CCENT certification and passing the 640-822 exam demands that you master networking basics, and part of that is knowing how to work with both physical and virtual Local Area Networks (LANs)...

CISCO CCNP Certification Training Tutorial: Priority Queuing for the ONT Exam
Submitted by: Chris Bryant

You can’t earn your CCNP certification without passing the Cisco ONT exam, and queuing is a huge topic on that exam...

CISCO CCNP Certification Exam Training for the ONT Exam: QoS Models
Submitted by: Chris Bryant

A large part of your CCNP training for the ONT certification exam should be spent studying the various ways we can implement Quality of Service (QoS) on Cisco routers and switches...

CISCO CCNA / CCENT Certification Exam Training: Broadcasts, Hubs, Routers, And Switches
Submitted by: Chris Bryant

In a previous Cisco CCENT certification exam tutorial, we talked about broadcasts and the potential of a broadcast storm...

CISCO CCENT / CCNA Certification Exam Tutorial: Comparing TCP and UDP Headers
Submitted by: Chris Bryant

During your Cisco CCENT and CCNA studies, you'll see that so many great TCP features - the three-way handshake, windowing, sequence numbering, error detection and recovery - are strictly TCP features...

CISCO Certification: An Introduction To Multilayer Switching And SVIs
Submitted by: Chris Bryant

Sure, you have to know all about SVIs and multilayer switching to earn your CCNP, but you also need to know about them because they’re so commonplace in today’s networks...

CISCO CCNA / CCNP Certification Exam Tutorial: EIGRP And Split Horizon
Submitted by: Chris Bryant

EIGRP is a major topic for your CCNA and CCNP studies, and one basic skill you’ll need to pass your Cisco certification exams is to identify situations where you need to enable or disable split horizon...

CISCO CCNP 642-901 BSCI Exam Tutorial: EIGRP Adjacencies And Secondary Addresses
Submitted by: Chris Bryant

I've read some non-Cisco documentation that EIGRP will not allow adjacencies to form when secondary addresses are used...

CISCO CCNP Certification BSCI 642-901 Exam Training: The EIGRP Adjacency
Submitted by: Chris Bryant

EIGRP is an important part of real-world networking as well as being a major topic on the 642-901 CCNP BSCI exam...

Ccna Certification Exam Training: Circuit Switching Vs. Packet Switching
Submitted by: Chris Bryant

CCNA certification exam training is all about learning the details, and an important part of your CCNA test prep is knowing the differences between Cisco router and switch technologies that are somewhat similar...

CISCO CCNA Certification Exam Tutorial: The Config Register And Password Recovery
Submitted by: Chris Bryant

Whether you're preparing for the CCNA certification exam or not, you must be prepared for the following question: "Hey, I reloaded this router and it wants an enable password...

Comptia Network+ Certification Exam Tutorial: Virus Attacks And Antivirus Programs
Submitted by: Chris Bryant

Whether you’re preparing to pass the Network+ or Cisco CCNA certification exam or not, you must not underestimate the importance of antivirus programs and virus definition updates...

Comptia Network+ Certification Exam Tutorial: Antivirus Programs
Submitted by: Chris Bryant

In the first part of this CompTIA Network+ certification exam tutorial, we looked at the different types of viruses and other invaders trying to get into our network, and how antivirus programs help to stop them...

IPod Battery Guide For Your IPod Nano
Submitted by: Brian H Logan

iPod battery life is an issue to most iPod users The iPod battery weakens over a period of time and it is not easily replaced...

Factors in Selecting a VAR
Submitted by: Lawrence Reaves

Selecting a Value Added reseller (VAR) is crucial and requires pain-staking assessment of their capabilities and track record, including those who are already delivering services into a client, even when the relationship has subsisted for many years...

IDC Market Forecast Predicts Static it Spend to 2013
Submitted by: Lawrence Reaves

An IDC Market Analysis and Forecast for 2009-2013 has been released and the results demonstrate a modest increase in IT spend by SMB’s worldwide – gross IT spend is predicted to rise by a mere 5...

VAR Issues – “Cheap” Usually Means Scalability, Service, And Reliability Are Sacrificed
Submitted by: Shell Harris

Value Added Resellers (VAR’s) come in all flavors, shapes and sizes – they provide a vital service to IT departments who are suffering from severe budgetary constraints, staff and skill shortages and issues in implementing and managing increasingly complex solutions...

Why You Should Buy a Notebook
Submitted by: Roberto Sedycias

The notebook computer is quickly replacing the desktop as most computer owner's favorite machine Not only is it portable for travel, it is also portable for use in the home...

The Clear Advantages Of A Sony Ericsson Satio
Submitted by: Gordon Millisons

Sony Ericsson Satio is a smart phone available at phone shops today with huge support for multimedia, touch screen feature and a lot more...

Did Windows 7 Boom or Bust?
Submitted by: John Dow

It's been a few weeks now since the launch of the Windows 7 release by Microsoft The launch in general was much lower key than past version launches, probably for a couple of reasons...

GBC H312 Laminator Review
Submitted by: Jeff McRitchie

The H312 replaces the H310 in the GBC HeatSeal line of pouch laminators Like its predecessor, this machine is targeted toward small business or home offices that do light to moderate amounts of laminating and need the flexibility to process larger documents...

GBC HeatSeal H435 Laminator Review
Submitted by: Jeff McRitchie

A new addition to GBC's Jam Free line of laminators, the HeatSeal H435 is presented as a laminating solution for small to medium sized organizations that need the flexibility of being able to laminate documents of many sizes, and of thicknesses up to 7mil...

GBC HeatSeal H520 Laminator Review
Submitted by: Jeff McRitchie

Aimed at the medium to large office market, the GBC HeatSeal H520 is designed as a solution for organizations that need to laminate documents of many different sizes...

GBC HeatSeal H535 Turbo Laminator Review
Submitted by: Jeff McRitchie

It is no secret that in today's business world, it's vital to produce top-notch work quickly That is hard to do that when you're waiting around for your laminator to work...

GBC ProClick P50 Binding Punch Review
Submitted by: Jeff McRitchie

As one of the premier manufacturers of binding machines, GBC produces machines both large and small for a wide range of uses...

GBC HeatSeal H700pro Laminator Review
Submitted by: Jeff McRitchie

GBC makes some great laminators and their HeatSeal H700pro is a perfect example It is one of the best laminators the company has manufactured...

GBC HeatSeal Ultima 35 Roll Laminator Review
Submitted by: Jeff McRitchie

If you need to buy a roll laminator for your school or business, the GBC Heatseal Ultima 35 is a laminator you should really take a look at...

Reviewing the GBC P210E Electric ProClick Binding System
Submitted by: Jeff McRitchie

The GBC P210E electric ProClick binding machine is a unit that makes it really easy to bind your important documents...

Isnare.com Footer Divider

© 2004-2009. Isnare Free Articles - An Isnare Online Technologies Free Articles Project. All Rights Reserved.   Privacy Policy